\nSingle piles \u00b1 2%; double and triple piles \u00b1 3%<\/li>\n
\nt: up to 8.5 mm = \u00b1 0.5 mm; over 8.5 mm = \u00b1 6 % t<\/li>\n
\ns: up to 8.5 mm = \u2013 0.5 mm; over 8.5 mm = \u2013 6 % s<\/li>\n
\nt, s: up to 8.5 mm = \u00b1 0.5 mm; over 8.5 mm = \u00b1 6 % s, t<\/li>\n
\nh: up to 200 mm = \u00b1 4 mm; over 200 mm = \u00b1 5 mm<\/li>\n
\nh: up to 200 mm = \u00b1 5 mm; from 200 to 300 mm = \u00b1 6 mm; over 300 mm = \u00b1 7 mm<\/li>\n
\nThe longitudinal deviation from straightness must not exceed 0.2% of pile length<\/li>\n
\nSheet pile lengths are permitted to deviate by \u00b1 200 mm from the ordered lengths<\/li>\n
\nCut at right angle to the longitudinal axis. The total deviation between the highest and lowest points in the cutting plane, measured on a single pile along the longitudinal axis, must not exceed 2% of pile width<\/li>\n
\nThe tolerance between the arithmetic weight (according to section tables) and weighed weight of the total consignment must be within \u00b1 5%<\/li>\n
\nThe interlocks shall have adequate free play so that the piles can be fitted into each other and they must engage in such a manner, that the forces necessary for the calculated connection can be transmitted
![\"spundbohle-produkte-schlossformen\"](\"https:\/\/www.spundbohle.at\/wp-content\/uploads\/2021\/12\/spundbohle-produkte-schlossformen-803x1024.jpg\")
<\/a><\/li>\n<\/ul>\n